Evs MulticamLSM Version 11.00 Operating Manual Uživatelský manuál stáhnout pdf (Strana 177)

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

Issue

11.00.C

167

16.3 How to Edit an Offside Line

Once the offside line has already been created, you can still load the sequence and edit

it.

To edit an existing offside sequence, proceed as follows:

1. In the Offside Line mode, press Last Cue until you reach the cue corresponding to

the requested offside sequence.

The following menu is displayed on the Remote Panel:

2. Press the A key (Edit).

3. Jog to move the pivot point to the position where you want to break the line.

4. Press TAKE to fix the pivot point.

5. Jog to break the line and change its inclination from the pivot point.

6. Repeat steps 3 to 5 for each new pivot point you want to define.

7. Press Mark to validate your changes.

16.4 How to Play the Offside Sequence

Once the offside line has been defined, you can play it as long as you are in Offside Line

mode. It will be played based on the settings defined in the secondary menu. For more

information, see the section 16.1.4 ‘Overview on the Offside Line Commands’, on page

165.

To play back an existing offside sequence, proceed as follows:

1. In the offside mode, press Last Cue until you reach the preroll cue for the requested

offside sequence.

2. Press PLAY to play the sequence.

The offside sequence is replayed according to the speed defined by the operator. When

the sequence reaches the keyframe, it is paused and the offside line is displayed

according to the fade in/out duration and the pause duration defined in the secondary

menu. You need to move the lever or press PLAY on the Remote Panel.

OSD

QUIT

EDIT

SIDE

UNDO

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 198 199

Žádné komentáře

Evs MulticamLSM Version 11.00 Operating Manual Uživatelský manuál Strana 177