Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Uživatelský manuál stáhnout pdf (Strana 149)

Multicam - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Issue

11.01.D

139

Important

The IN and OUT points cannot be marked on a transition (including split audio

transitions and swap zones) or on a split zone (the key will flash red when it is

the case).

11.18.5 How to Perform a Replace

You first define the Replace function in the Replace Edit mode. Then, you execute the

Replace function in the Replace Playback mode.

To perform a Replace, proceed as follows:

1. Open the playlist in which you want to replace a section in Playlist Edit mode.

2. In Playlist Edit mode, press Menu on the Remote Panel to access the secondary

menu.

3. Press the A key to enter the Replace Edit mode.

4. Use the jog dial to reach the desired IN point for the Replace section and press the IN

key to mark it.

When the IN point has been marked, the display switches to:

The Int. Loop (B) and Ext. Loop (C) keys are blinking.

5. If you want to specify the OUT point for the Replace section at this stage, jog to the

requested point and press the OUT key. Otherwise, you can define the OUT point

while you perform the Replace.

6. Press the B or C key to select whether you will use the internal loop or external loop

to perform the Replace.

For more information on the loop type and additional parameters, refer to the section

‘Loop Mode in the Replace Function’, on page 140.

The playlist is cued before the IN point (to create guardbands), ready to be initiated.

A message appears on Remote: “Start Replace: lever or play button”.

7. Push the lever or press the Play key on the Remote Panel to shift to the Replace

Playback mode and start the Replace process.

8. If you have not defined the OUT point for the Replace in step 5, press the OUT key

when you reach the desired OUT point.

While the Replace is being performed, the following messages are displayed on the

OSD:

“Replace in Progress”

“Clipping guardbands”

“Replace by clip xxx”

On the Remote Panel, a confirmation message pops up:

9. Press Enter on the Remote Panel to validate the Replace:

The material between the IN and OUT points is replaced with the newly created clip.

The playlist returns to Playlist Edit mode, positioned at the end of the inserted clip.

You can also cancel the Replace by pressing the Menu key on the Remote Panel.

Cam A

+2fields

Replace

Int.Loop

Ext.Loop

Replace in/out by clip xxx ?

MENU: Cancel – ENTER: OK.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 208 209

Komentáře k této Příručce

Žádné komentáře

Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Uživatelský manuál Strana 149

Komentáře k této Příručce

Související produkty a manuály pro Příslušenství pro video Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper