EVS XT2+ Uživatelský manuál stáhnout pdf (Strana 96)

Warning

Some video formats allowed on an XT2+ server create clips that are not

compatible with previous hardware. When an incompatible format is selected, a

warning will be issued at application startup. In addition, the video format

information displayed on the Server tab of the Multicam Configuration window

indicates any incompatible information.

3.3.3. Phase Definition Settings

Introduction

The Phase Definition settings are available on the Server tab in the server-based

application (1

page) and web-based interface in the advanced mode.

The Phase Definition settings are highlighted in the screenshot of the server-based

application shown below:

SD (Standard Definition)

Description Allows adjusting the digital main phase of the mainframe for

the standard definition. The value is adjusted by steps of half

pixels.

The values depends on the genlock type (See section "Video

and Reference Settings" on page 76).

Values • If the Genlock type is set to ‘Blackburst’, the main phase

for SD can be adjusted by steps of half pixels (37 ns)

between - 12000 ns and +15000 ns.

• If the Genlock type is set to ‘Tri-Sync’ (only possible in HD

resolutions), the main phase for SD can be adjusted by

steps of half pixels (37 ns) between - 30000 ns and

+32000 ns.

XT2+ Server- Version 11.01- Configuration Manual

3. Multicam Configuration 86

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 233 234

Žádné komentáře

EVS XT2+ Uživatelský manuál Strana 96